Contemporary Salon Table.

Leo- I think you may want to look at replacing your square.

Nice work - Mortise and tenon at the - sort of - right angle joints?

30.9º at the joint. I did a half lap by dadoing both pcs.

I added another picture to show the half lap.

Leo,
I couldn't expand the photos enough to figure out what kind of joinery you used where the leg meets the base.
Geoff

The base to leg joint is just a miter with a couple screws in it supported by West system epoxy. If you mean the table to leg joint there is a pc of particleboard that is screwed into the top of the legs and then it nests inside the tabletop between the rim.