Biesse Arrow W OSAI 10 Control

07/01/2014


From original questioner:

Hi All

I'm looking at a used Arrow with an OSAI control, 1999 vintage.

Can this machine/control import a dxf file of a nested sheet and assign the proper tools etc without too much trouble, or is it better to send it G code?

Also, is it possible to turn off the vacuum pump automatically when the job is done?

Thanks in advance.

From contributor Ma


Direct .dxf import is not even possible on that control, g-code only.
Hope this helps.
Mark T.

From contributor Dr


Thanks

From contributor De


I know a guy that had a twin table Arrow of that same vintage. He hated it from day 1, and it was the happiest day of his life when they picked it up.

From contributor Dr


Hi Derreck

Why'd he hate it so much?