|Home » Forums » Cabinetmaking » Message||Login|
You are not logged in. Consider these WOODWEB Member advantages:
1" overlay euro hinge2/25/19
Is there a two piece clip type euro hinge available that will give a 1" overlay on a frameless box?
I would prefer not to use the tec face frame hinges. I seem to recall that a 170 degree hinge with a restriction clip might do the job. Suggestions?
You’re pretty accurate about a solution here. I can think of 3 possibilities from Salice.
2. If you must have the full 1” overlay, then your solution is correct. You would use the 155-degree hinge, 0mm mounting plate and the restrictor clip to limit the opening to 120 degrees. A 9mm edge bore distance would be used.
3. Another solution would be to use to use the Salice 94-degree, F series hinge with a 40mm cup. With this, you would use a 0mm mounting plate and a 6.4mm edge bore. With this hinge, you could get up to a 1-3/8” overlay.
Here are 2 drawings showing solutions 2 and 3.
Best of luck,
Correction on point #2:
2. If you must have the full 1” overlay, then your solution is correct. You would use the 155-degree hinge, 0mm mounting plate and the restrictor clip to limit the opening to 131 degrees. An 11mm edge bore distance would be used.
Thank you, Dennis.